UNDER CONSTRUCTION

1/ Remove the female part of the tubes.

2/ Open the plate pocket to install the cummerbunds from inside the plate pocket.

3/ Feed each end through the corresponding slots. CAUTION: the cummerbunds must point downward.

4/ Test the elasticity of the setup.

5/ Remove the cord lock and pass the cord out through the opening. Reinstall the cord lock and secure it with a knot.

6/ Close the plate pocket.

For this assembly, we recommend using a steel ruler or similar tool and a flat-head screwdriver. These tools are not essential, but they make assembly much easier.

1/ Insert the ruler to make it easier to slide in the long rigid part (composite side up), then push.

2/ Pull the strap out (by default, we recommend the second-to-last slot). You can use a ruler to help pull it out.

3/ Lock the end in place the same way as on a MOLLE pouch and pull the slack through from the other end.

4/ Pass the anchor through the D-ring and fold it back.

5/ Insert the anchor into the MOLLE wherever you like. Adjust the exit anchor points, etc., to fit your body type.

6/ Close the shoulder cover.